Home / Services / Emergency water extraction

Emergency Water Extraction in Apex, NC

Standing water on the floor is still soaking into carpet, pad, baseboards and drywall. Stop the source if it is safe, then call. Our line is open 24/7.

24/7 emergency lineApex, NC · 27502 · 27523 · 27539
The short answer

Emergency water extraction is the removal of standing water from a home with pumps and extraction units, so floors, walls and belongings stop absorbing it. The sooner it happens, the more carpet, pad, flooring and drywall can usually be saved. Even a quarter inch of water across a 1,000-square-foot floor is roughly 155 gallons, far more than a household wet vac can handle without constant emptying.

Right now

What to do while you wait for help

Stop the sourceShut off the main water valve or the valve at the failed fixture. If the water is rain or groundwater, note where it is entering.
Check the powerIf water is near outlets, appliances or the electrical panel, do not step in it. Switch off power only if you can reach the breaker without standing in water; otherwise stay out of the water and call an electrician or your power company. Call 911 if anyone is in danger.
Assume it may be contaminatedWater from a toilet, a sewer backup, a washing machine or outside is not clean water. Keep children and pets out and avoid wading through it.
Photograph before you move thingsCapture the water, the source and the damage for your insurer, then lift furniture legs, rugs and small items out of the water.
Call for extraction and dryingRemoving the water is step one. The materials it soaked into still need to be dried, or moisture stays behind.
Local causes

Why standing water happens in Apex homes

  • Failed appliances and supply lines. Washing machine hoses, dishwasher lines, water heaters and ice-maker lines can release a lot of water in a short time, especially while no one is home.
  • Heavy summer storms and tropical remnants. Downpours can overwhelm gutters and push water in through doors, windows and low areas.
  • Slow-draining Piedmont clay. Clay soil around the Triangle absorbs water slowly, so water can pool against a foundation instead of soaking away.
  • Frozen and split pipes. A pipe that split during a freeze can release water when it thaws.
Avoid these mistakes

What not to do

  • Do not use a household vacuum. It is not built for standing water and can shock you or fail.
  • Do not switch on lights or fans under a wet or sagging ceiling. Water can be in the fixture or wiring.
  • Do not assume a dry-looking floor is dry. Water hides under flooring, behind baseboards and inside walls.
  • Do not wait until morning. The EPA says to dry water-damaged materials within 24 to 48 hours to prevent mold.
The process

How professional extraction works

1

Safety and water category

Confirm the power is safe and identify whether the water is clean, gray or black. That decides what gets handled how.

2

Extract standing water

Use pumps and extraction units to pull water off hard floors and out of carpet and pad.

3

Lift and inspect

When needed, lift carpet and remove pad so the subfloor can dry. Check baseboards and the bottoms of walls.

4

Find hidden moisture

Moisture meters show water that has traveled into wall cavities, cabinets and under flooring.

5

Start structural drying

Air movers and dehumidifiers take over from extraction. See our full list of services.

6

Document the job

Photos and moisture readings support an insurance claim and show when the structure is dry.

Related

Related water damage help in Apex

Burst pipe water damage

Drying and repair after a supply line splits or freezes.

Sewage backup cleanup

Safe removal and disinfection of contaminated water.

Storm and roof leak damage

Rain through the roof, windows or walls after a storm.

Appliance and water heater leaks

Washers, dishwashers, water heaters and AC drain lines.

General information, not legal or insurance advice. See our insurance guide or go back to the Apex water damage homepage.

Common questions

Frequently asked questions

How quickly does water need to be extracted?

As soon as possible. The EPA says water-damaged areas and items should be dried within 24 to 48 hours to prevent mold, and extraction is the first step in getting there.

Can wet carpet be saved after extraction?

Often, if the water was clean and extraction and drying start quickly. Carpet and pad that soaked up sewage or floodwater usually cannot be made safe and are removed.

Is a wet-dry vacuum enough for a flooded room?

For a very small, clean spill, it can be. For more than a small area, or for anything that reached walls or subfloors, extraction plus structural drying is needed, since fans and a shop vac do not reach moisture inside materials.

Does insurance pay for water extraction?

When the cause of the water is a covered event, such as a sudden burst pipe, reasonable emergency mitigation is typically part of the claim. Coverage depends on your policy, so ask your insurer before you decide what to file. See our insurance guide.

Need help now

Water damage can’t wait. Call now.

Tell us what happened and what is wet. We will talk you through the next steps. Our line is open 24/7.

Call (919) 503-3409
Call (919) 503-3409